#Carpenter bee traps how to#
#Carpenter bee traps plus#
#Carpenter bee traps tv#

#Carpenter bee traps how to#

Once you’ve caught a few, you can change out the bottle for a new one and catch some more! Check out our article on How to Deal with Carpenter Bees to find out more.Carpenter Bees are industrious insects and can drill hundreds of holes in the wood on your home and barn in search of a place to lay their eggs. Hang your new trap and you’re ready to catch them all! Then attach the screw eye near your most-frequented carpenter bee location. Last step is to squeeze the bottle cap into the hole on the bottom and screw the bottle on. The home center I got the eye and hook from did not have them small enough in stainless steel or galvanized. Mine screwed in snuggly between the two roof pieces. Drill them at a 45 degree angle to eliminate the amount of the sunlight that can get through once it’s hanging. Then turn your trap on it’s side and drill a hole about 2 inches from the top with the 1/2 inch bit on 3 of the sides.

Drill in the cap of your plastic bottle cap.

#Carpenter bee traps tv#

You would think having a construction company and a home improvement TV show in your office would mean you’d have access to plenty of tools in the shop…but when all the crews are out on jobs, you’re stuck with the rusty leftovers. Hopefully you can scrounge up a drill bit a little shorter than the one I was forced to use… This is an approximate size since it depends on the size of your plastic bottle cap. While you have it upside down, use the 1 1/4 inch drill bit to drill a hole in the center of the bottom. It won’t cover the entire surface, but it will cover the hole. Then I placed them on top of the assembled sides and attached them with a few screws.įlip it over and attach the 6 1/2 inch piece to the bottom using the same screws. So I stacked them on the chop saw and cut some of the width. I wanted the trap to have a “roof” that overlapped the sides, but the (2) 7 inches pieces were too wide. Make sure you go through the side of the piece underneath! This is how it’s pieced together:īut turn it on its side to make it easier to pre-drill and screw the pieces together. You’ll need to cut (4) pieces at 8 inches from the cedar, (2) pieces at 7 inches, and (1) piece at 6 1/2 inches. Here are the materials you’ll need to make one for your house:

#Carpenter bee traps plus#

Plus it should hold up fairly well outside. I used cedar instead of the many options on our lumber rack to hopefully attract the bees easier since it’s different from the wood on the rack. Or more like they don’t leave because that’s where the light is.Īfter picking up a fresh piece of cedar and a soda from the home center, I was able to get to work. The bees fly in the hole, see the light in the bottle, then fly into the bottle where they are then trapped. Then you put a clear bottle on the bottom. The holes drilled on the body of the trap are at an angle so sunlight doesn’t get in. I did a little research on the ole Google to make sure I was making it right. (But if you’d rather but yours, here’s a similar one I found on Amazon.*) But it’s a simple design and could be homemade cheaper.

I had seen one for $18.99 at a local hardware store. Spring has sprung in Mobile, Alabama! So of course the bugs are out and about too! In particular, there has been an increase in the big, black furry carpenter bees around our office.Īnd since we keep lumber leftover from various projects racked outside, we needed to do something to contain these drilling creatures! So I built a Carpenter Bee Trap.